TitleFactory & - Activation

TitleFactory Activation

TitleFactory activation occurs after the product is purchased. Until the product is activated it will run in a demo mode. In demo mode the products will be limited to 5 images created for the TitleFactory.

TitleFactory is registered on a one-user per machine basis.

After successfully paying for TitleFactory, you will be directed to an Order Confirmation page. At this point you can Activate the product immediately.

To activate TitleFactory electronically:

Make sure that you are connected to the internet.
Start a TitleFactory product.
If you require a proxy server (not needed in most cases) then go to Help>Proxy Set-up and fill in your proxy requirements.
Go to Help>Electronic Activate ...
Enter your email address used to pay for the product. NOTE that the email address must be placed exactly as on the order, that is, using the same upper and lower case letters. Please make sure that there are no spaces at the beginning or end of the email address.
Press OK.
An 'Activation Complete' message will be displayed.
Quit and Restart Product.

Please note that all information that you enter is kept confidential and will not be shared with anyone, or any institution, ever, unless required to do so by the laws of the land. That is our privacy policy, plain, and simple.

If you cannot connect to the internet on the machine that you want to run TitleFactory then you can activate the product manually, however, please note that this method of activation may take up to a week. If you wish to activate the program manually, perform the following steps.

To activate TitleFactory manually:

Start a TitleFactory product.
Go to Help>Registration Info...
Record the Hardware ID Code. Make sure that the complete HW-ID code is recorded.
Send an email message (on a machine that is connected to the internet) to tfsales@titlefactory.com with the Hardware ID Code and the email address that was used to pay for TitleFactory.
You will receive an email message (within several days) with an Activation Code that is required to activate the product on your machine.
Go to Help>Electronic Activate ... and enter the activation code that was provided to you.
Quit and Restart Product.